Any size, any TV, any wall — plasterboard, brick, stud, chimney breast. We supply the right bracket for your TV, conceal every cable inside the wall, relocate sockets if needed and leave the plaster finished and ready to paint.
The reason people regret a DIY wall mount is the cable. A trailing power lead and HDMI down the wall ruins the look. Every mount we do includes either a fully recessed in-wall power and HDMI run, or — if the wall can't be channelled — a colour-matched cable trunking that genuinely disappears.
Wrong bracket is the #1 cause of a TV that sags, sits crooked, or pulls fixings out of plasterboard. We arrive with a survey kit, check stud spacing, VESA pattern and wall type, then fit the right bracket for the job:
Period chimney breasts and modern stud walls are where most installers come unstuck. We fit heat-rated mounts above working fireplaces, drill into solid brick where stud anchors won't hold, and run cabling around the alcove rather than across the room. We make the plaster good before we leave.
Fixed prices from £95 for a flat or tilt mount with bracket supplied and basic cable management. In-wall cable concealment, socket relocation and full-motion brackets are quoted up front before we drill anything.
Yes, with the right kit. We use heat-rated brackets above working fireplaces and route cables through the chimney breast or around the alcove. We'll check the wall temperature before recommending it.
Yes — either inside the wall via a recessed power and HDMI kit, or in colour-matched trunking when the wall can't be channelled. We don't leave trailing cables.
Everything from 32" up to 85". For TVs over 65" we always check the wall fixings can take the weight before fitting.
We can — we carry a full range, or you can supply your own. Either way the install price is the same; brackets are charged at trade.